10-10-c

[12 piece bucket]

2-G HINGE MOTION . . . These motions actually duplicate the three possible hinge mountings – horizontal, vertical and angled – representing all three Basic Planes (7-5). The Hands can be educated to reproduce them by holding at least one Hand vertical or parallel to the corresponding Basic Plane. These motions also duplicate the motions of paddles of a paddlewheel rotating around its axis vertical to one of the three Basic Planes. And an equivalent could be “Clubface Paddlewheel Action” executed as a Left Wrist Paddlewheel Motion. Thus, though some procedures may cause the Clubface to “Close” in relation to the Plane Line, none will be an actual “Roll” of the Hands. See 2-C and 6-B-3-0. There is, however, the “Release Roll” (Swivel) which is a true rotation of the Hands into Impact alignments by Accumulator #3 with (10-18-A only). After the selected Hinge Action has been executed, the Swivel is again useful for Snap Rolling the hands into their On Plane Condition for the Finish (8-12). That is the Geometry of Hinging.

6-B-1-0 THE FIRST POWER ACCUMULATOR is the Bent Right Arm – the Hitter’s (7-19) Muscle Power Accumulator. Even though the Right Bicep is active per 7-3, the Backstroke (8-5) is always made with the Right Arm striving to remain straight. But the straight Left Arm restrains this continuous Extensor Action of the right triceps with and effortless Checkreign Action. Consequently, during Release (7-24) the Right Arm can straighten only as the Left Arm moves away froM the Right Shoulder. This results in a smooth, even Thrust for acceleration of the Lever Assemblies (6-A) from an otherwise unruly force. Active or Passive, the straightening Right Elbow with its Paddlewheel Action, powers, guides, and regulates the #3 Accumulator Motion (7-1 but not the actual Clubface aligning (1-F). Study 2-M, 7-11 and Components 19.

7-18 LEFT WRIST ACTION . . . Then understanding and executing the Left Wrist Action per 2-N-1, synchronizes the entire procedure. Trigger Delay alters little geometrical but magnifies the physics. The Paddlewheel Action of the straightening Right Elbow (10-10-C) initiates and sustains the #3 Accumulator Hand Motion (4-D-0) unit the Both-Arms-Straight and Zero Accumulator #3 position of Full Extension – but, of course, under the guidance of the Flat, Vertical Left Wrist Hinge Action (2-G). Accumulator #3 Action is not Lever Assembly Extension. See 2-P. With the Endless Belt Effect, The Belt (Hands) and the Clubhead have the RPM but the Surface factor sets in and gives the Clubhead greater MPH – in reverse proportion to the size of the Pulley (the smaller, the faster). That is, raised Hand Position – reducing the Accumulator #3 Travel –plus Trigger Delay. Conversely – a larger Pulley (lowered Hands) requires a higher Handspeed and an earlier Trigger. See 6-B-3-A, 6-F and 6-N-0.

10-2-D STRONG DOUBLE ACTION T/V/A Now the Right Wrist is Vertical and the Left Wrist is Turned to the top of the Clubshaft so that the Left Wristcocking motion will be on the same line as the Right Wrist Bend. The #3 Pressure Point and the left thumb are also on the same line as the Right Wrist Bend. Double Action – same as 10-2-C.

Very compatible with the Cut Shot procedures. Any Left Wrist Bend at Impact Fix should be maintained throughout the Stroke.

This Grip Type features maximum Wristcocking action and strong support for both Acceleration and Impact loads. The palm of the Right Hand moves toward Impact exactly like a paddle-wheel rotating On-Plane – no separate Rolling Motion until after Impact. See 10-10-C.

10-10-C ANGLED HINGE ACTION This simultaneous “Closing and Layback” procedure holds the Flat Left Wrist vertical to the Inclined Plane (2-D, 2-G). This is identical to the Paddle-Wheel motion of the straightening Right Arm but is a superior procedure (1-F). It greatly simplifies Hitting (10-19-A). The Shoulder Turn changes the appearance of this 10-18-C Wrist Action but not its Feel (see 7-10). Its Slice tendency must be compensated per 2-J-1. The “Laying Back” action makes Ball location very critical. Study 4-D-0.

10-19-0 GENERAL . . . Hinge Action does NOT differentiate Hitting and Swinging. All are interchangeable – with reservations. Hitters using Horizontal Hinging must consciously resist the tendency of the Right Arm Paddlewheel Action toward Angled Hinging. Swingers using Angled Hinging must consciously resist the tendency of Centrifugal Force toward Horizontal Hinging. Both procedures require skill in Clubface manipulation per 7-2.

10-24-E AUTOMATIC SNAP RELEASE This procedure drives the Lag Pressure Point through a Snap Release (6-N-0) as if there were to be no Release at all. The Paddlewheel Action of Angled Hinging per (10-10-C) or the Throw Out Action of Accumulator #3 (6-B-3-0), if unhampered, will whip the Hands and the Clubface into impact alignment per 7-23. A strong whiplash type of motion is also effective. With Single Wrist Action (10-18-C) a Snap Release will return the Hands to their Vertical condition before Triggering and ensure a Downward rather than a Forward course of the Clubhead into Full Extension. Study 2-P, 6-B-2-0 and 10-11-3-0.